[RESOLVED] Password request on first Agent installation + Software installation as administrator
Published: October 4, 2019 - 2:55 PM
Hello,
WAPT Server version: 1.7.4
WAPT Agent version: 1.7.5.6177
WAPT Setup version: 1.7.5.6177
WAPT Deploy version: 1.7.5.6177
Database status: OK (1.7.4.0)
Disk space: 70% free.
Everything is in the title.
When a PC shuts down, it loads the agent correctly, but at the end of the installation, it asks for the WAPT server admin password.
I've read some articles but haven't found a solution, or solutions I've tried without success.
Do you have any tips or is there something I've missed in the server installation?
Another point:
via WAPT, I have software that requires administrator privileges to install. The WAPT server is blocked at this point.
I read that it's possible to launch the WAPT service as an administrator with a username and password, which seems more like a security vulnerability than anything else. Do you have a solution to suggest?
Sincerely,
William
WAPT Server version: 1.7.4
WAPT Agent version: 1.7.5.6177
WAPT Setup version: 1.7.5.6177
WAPT Deploy version: 1.7.5.6177
Database status: OK (1.7.4.0)
Disk space: 70% free.
Everything is in the title.
When a PC shuts down, it loads the agent correctly, but at the end of the installation, it asks for the WAPT server admin password.
I've read some articles but haven't found a solution, or solutions I've tried without success.
Do you have any tips or is there something I've missed in the server installation?
Another point:
via WAPT, I have software that requires administrator privileges to install. The WAPT server is blocked at this point.
I read that it's possible to launch the WAPT service as an administrator with a username and password, which seems more like a security vulnerability than anything else. Do you have a solution to suggest?
Sincerely,
William