Tranquil IT Forum

Hello,

I've set up a test environment with WAPT 1.7.4 installed on an Ubuntu 16.04 server.
I've registered two Windows 10 client machines on it, which are on the same DHCP network as the server.

Installation and registration went smoothly. However

, from the console, executing commands (search for updates, install updates, uninstall, etc.) only works for the machine on which the console is running the command.
Specifically: PC-A and PC-B.

On PC-A, I open the console, select PC-A, and run a command; it executes.
On PC-A, I open the console, select PC-B, and run a command; nothing happens.
On PC-B, I open the console, select PC-B, and run a command; it executes.
On PC-B, I open the console, select PC-A, and run a command; nothing happens.

The WAPT server logs indicate that it received the command from the console and that it is sending the command to the client machine, but nothing happens after that. The WAPT client logs do not indicate that it received any command.

Any ideas on how to investigate this problem more concretely?

It would appear that this was due to a time difference between the two workstations, but the logs did not indicate anything in this regard.

So that's resolved.